Home › Blog › OpenView

How to Install TV Aerials for a Clear Picture

OpenViewBy our Hout Bay DStv teamUpdated 16 October 20268 min read

A clear picture from TV aerials comes down to three things: where the aerial points, how high it sits and how cleanly the signal travels down the cable. In Hout Bay, with mountains on three sides, the first of those matters most. Get the direction right and half the battle is won.

Quick answer

To install TV aerials for a clear picture, find the direction of the transmitter, mount the aerial as high as safely possible with a clear view that way, and use good coaxial cable with sealed connectors and as few joins as possible. Then run a channel scan and fine-tune the aim while watching signal quality.

First, find which way your TV aerial should point

Most outdoor aerials are directional. They hear best from straight ahead and poorly from the sides, so a perfect aerial pointed the wrong way gives you a poor picture.

The easiest way to find the direction is to look at nearby roofs. If most aerials in your road point the same way, follow them. On the slopes above Hughenden and Scott Estate, you'll often see aerials angled to peek past a ridge rather than straight across the valley.

Technician tip

Mountain shadow from Chapman's Peak and the Karbonkelberg can block land-based signal in parts of the valley. If you can't see any aerials on nearby houses, your street may get better results from free satellite TV through OpenView installation instead.

Step-by-step: how TV aerials are installed properly

Here's the order a careful installer works in. The indoor steps are safe for you to do yourself. Anything on the roof or a ladder is for a technician.

  1. Test the signal. A meter shows the strength and quality at different spots around the house.
  2. Choose the aerial. Match it to the signal: a compact aerial for a strong one, a high-gain directional model for a weak one.
  3. Pick the mounting point. High, solid and with a clear line to the transmitter, usually a gable wall or chimney.
  4. Fit the bracket and mast. Fixed into solid masonry, with stays on a tall mast.
  5. Run the cable. One clean length of good coaxial cable, clipped down so it can't flap.
  6. Seal the joints. Every outdoor connector gets a weatherproof boot or tape.
  7. Connect indoors. Fit a proper wall socket and a short lead to the TV.
  8. Scan and fine-tune. Run a channel scan, then adjust the aim for the best quality reading. It's the same idea as using a signal finder for DStv on a dish.

Safety first

Please don't climb onto a roof or up a ladder to fit or turn an aerial yourself. Hout Bay homes are often on steep slopes, and the wind off the Atlantic can catch a mast like a sail. Overhead power lines add another risk, so leave roof work to a technician.

Indoor, roof space or outdoor: which mount suits you

Not every home needs a mast. The right mount depends on how strong the signal is where you live. This table sums up the options we use most.

MountWhen it worksWatch out for
Indoor aerial on a shelf or windowStrong signal, clear view, short distance to the towerPeople walking past, walls, other electronics
Aerial in the roof spaceFair signal and a roof that lets it throughMetal roofs, foil insulation and solar panels
Wall bracket on a gableMost homes with an open side facing the towerSalt on the fixings, wind on the bracket
Tall stayed mastWeak signal or a ridge in the wayNeeds careful fixing and regular checks

An indoor aerial is a fair first test, and it's something you can do safely. Put it high up near a window that faces the transmitter, then run a channel scan from your TV's menu.

Planning an outdoor mount on a wall that already holds a dish? Our satellite dish alignment team can plan both so neither blocks the other.

Need DStv installers in Hout Bay?

Tell us what you need or what your screen is showing. We give you a clear price before we drive out.

Cable and connectors: where most bad pictures start

We see more poor pictures from bad cabling than from bad aerials. Every joint, kink and loose plug leaks a bit of signal. On a long run from a hillside roof down to a lower-level lounge, those losses add up fast.

  • Use good shielded coaxial cable, not thin bell wire or old cable from a previous house.
  • Avoid twisting wires together and taping them. Use proper connectors.
  • Don't coil spare cable behind the TV. Cut it to length.
  • Use one quality splitter for extra rooms, not a chain of cheap ones.

If the cable behind your TV cabinet is already a tangle, our guide to every decoder port explained helps you sort out which lead goes where. For a neat finish on a new screen, our TV wall mounting team can hide the cables in the wall.

Protecting TV aerials from salt air and wind

The Atlantic is hard on anything metal. Salt air corrodes connectors and fittings, and once water gets into a cable it slowly ruins the picture. Homes in Llandudno and along Victoria Road see this faster than homes further up the valley.

We use stainless or galvanised fittings and seal every outdoor joint. It's the same care we put into dishes, which our post on salt and wind signal problems covers in more detail.

Good to know

Holiday homes and rentals that stand empty for months often have the worst aerial faults, because nobody notices the picture getting worse. A quick check before the season saves guests a frustrating first night.

Your TV, the scan and the final tune

Once the aerial is up and the cable is in, the TV does the rest. Any television with antenna input and a built-in digital tuner can find the free-to-air channels. Older sets may need a small set-top box.

  1. Open the TV's settings and find the channel or tuning menu.
  2. Choose the aerial or antenna input, then start an automatic scan.
  3. Check the signal quality screen on a few channels, if your TV has one.
  4. Save the channel list and test each one for a minute or two.

If some channels still break up, the aim needs a small adjustment on the roof. That's the job for a technician with a meter, not a guess from a ladder.

What affects the cost of a new aerial

TV aerial prices on their own don't tell you much, because the real cost depends on the mount, the cable run and how many rooms you want connected. A steep site or a tall stayed mast takes longer than a simple wall bracket, so we always quote first. Ask our team for a current quote.

Book an aerial install in Hout Bay

If the steps you can do safely don't give you a clear picture, call a technician. Our TV aerial installation service covers the valley, from Penzance Estate to Northshore, and we test every channel with you before we leave.

We also handle DStv installation in Hout Bay if you'd rather add a dish as well. Get in touch with us to book.

TV aerials: FAQs

How do I know where to point my TV aerial?

Look at the aerials on houses near you. If most point the same way, that's usually the direction of the transmitter. For the best result, a technician uses a signal meter to find the exact aim and the best spot on your roof.

Can a TV aerial go in the roof space instead of outside?

It can if the signal is strong and the roof lets it through. Metal roof sheeting, foil insulation and solar panels can block a lot of signal. A roof space aerial is worth testing, but an outdoor mount usually gives a steadier picture.

Why is my TV aerial not picking up channels in Hout Bay?

The mountains around the valley block land-based signal in some streets. It could also be a loose cable, water in a connector or a TV that needs a fresh scan. Check the cables and rescan first, then ask a technician to test the signal on site.

How do I connect TV aerial cable to the wall socket?

Use a short coaxial lead with a proper plug at each end. Push one end firmly into the wall socket and the other into the TV's aerial input. Then run a channel scan. Avoid loose or bent plugs, as they cause a lot of poor pictures.

Can I use old TV aerial cable for a satellite dish?

It's best not to. Older aerial cable is often thinner and not made for the higher frequencies a satellite dish uses, so the picture can suffer. A technician will check the cable and replace it if it's not suitable.

Talk to our Hout Bay team

Call or WhatsApp us for a quote. We answer quickly and we always price the job before we arrive.