Communal systems

Communal / Complex DSTV Installation in Hout Bay

Communal DSTV for Hout Bay complexes and multi unit properties. One dish and a multiswitch feeding every unit, so residents get signal without a dish on every wall.

Communal / Complex DSTV Installation in Hout Bay

A communal system puts one dish on the building and distributes it through a multiswitch to an outlet in each unit. Residents plug in a decoder and get signal. The body corporate stops dealing with a wall covered in individual dishes, and the roof stops collecting new penetrations every time a unit changes hands.

In Hout Bay there is a stronger reason than appearance. Every private dish on an exposed building is another set of fittings corroding in salt air and another mount the wind can move. Consolidating to one properly specified dish means one piece of hardware to maintain instead of a dozen neglected ones.

Communal satellite dish and multiswitch feeding units in a complex
  • Roof survey for line of sight and safe mounting
  • One dish peaked on a meter with rain margin
  • Multiswitch sized to unit count plus headroom
  • Coax run to a labelled outlet in each unit
  • Every outlet metered and recorded at handover

How a communal system is built

We survey the building for a dish position with line of sight out of the valley, mount and peak the dish, install a multiswitch in a dry protected location, then run coax to an outlet in each unit and meter every one. The design is sized for the number of units plus a little headroom, so a future conversion or an extra outlet does not mean starting over.

Working with the body corporate

We quote in a form a trustee meeting can actually use, setting out the dish position, the cable routes through common property, where the multiswitch lives and who is responsible for what afterwards. We will attend a meeting or answer questions by email if that helps the decision. Removing the existing private dishes and making good the wall can be included in the same scope if the scheme wants a clean result.

Suited to how properties here are used

Many Hout Bay blocks hold a mix of permanent residents, long lets and short stay holiday units. Occupancy changes constantly, and a communal outlet means a new arrival just plugs a decoder in rather than booking an installer and drilling another hole. On the steeper sites where units sit on different levels, a central distribution point also gives us far shorter and tidier cable runs than individual installs would.

Maintenance and faults

With one dish serving everyone, a fault affects everyone, so the outdoor hardware is specified for the conditions. Stainless fixings, a braced mount against the wind, sealed connectors, and the electronics kept out of the salt air. If a single unit loses signal we can usually isolate it to that outlet from the records we leave. Monday to Saturday, with emergency response for managed buildings. info@dstvhoutbay.co.za.

Common questions

Communal / Complex DSTV Installation in Hout Bay: your questions answered

Does a communal dish mean one shared subscription?

No. Each unit keeps its own DStv account and its own decoder. The communal part is only the dish, the multiswitch and the cabling that delivers signal to each outlet. Nobody sees or shares anyone else's channels, and a resident can change or cancel their package without affecting the rest of the building.

Can existing private dishes be removed?

Yes, and on an exposed Hout Bay building it is usually worth doing. We take them down, plug and seal the redundant penetrations, and make the wall good ready for paint. Those old mounts are often corroded and leaking anyway, so removing them solves a water problem as well as tidying the building up.

What happens if the communal system fails?

One dish serving many units makes response time the priority, so we keep the layout and the outlet readings on file and treat managed buildings as priority callouts. Most failures we see here are on the outdoor side, a corroded connector or an LNB that has taken salty damp, which is why we specify and seal that part properly from the start.

Will the cabling be visible through the complex?

We plan routes through ducts, ceilings and existing services wherever the building allows, and use trunking that can be painted where a surface run is unavoidable. On split level Hout Bay complexes there is usually a sensible vertical route. We walk the proposed routes with the trustees or the managing agent before any drilling starts.

Book communal / complex DSTV installation in Hout Bay

Monday to Saturday across Hout Bay and the surrounding areas, with emergency callouts when a business is down.